PLC Baced Horizontal Plastic Injection Moulding Machine

Min Order :

OverView

Company : PAYAL INDUSTRIES

Phone : 0091-9824012046

Mobile Phone :

Adress : Plot No.1892, Mahavirnagar, Near Bajarang Ashram, Thakkarbapanagar, N.H.8,Ahmedabad

City : Gujarat

Country : India

Email : info@payal-india.com

website : www.payal-india.com

  •  Standard Features5 Point double Toggle clamping system of steel casting with steel link and steel bushes with tempered steel pins
  • Hydraulic ejector through plate with multiple ejector cycles through nine strokes
  • Multiple point automatic lubricating system
  • Clamp closing and clamp opening profile with programmable and independent strokes and speeds
  • Low pressure mould protection with high mould safety
  • Freely programmable control of max. 2 core pulls and air for the control of max. 1 valve
  • Mould opening and clamping in Four stages
  • Mould setting gear arrangement by Hydro-motor
  • Square tie bar distance with large mould height
  • High tensile, hard-chrome platted tie bar
  • Electrical interlocks in front and rear safety guards
  • Ceramic heater
  • High torque hydraulic motor for screw drive
  • Automatic suck back system
  • Four stage injection and four stage holding time
  • Cold start protection
  • Gas-nitride screw barrel with standard L/D Ratio
  • Injection movement is actuated by two hydraulic cylinders, for perfect alignment to the clamp unit
  • Injection unit sliding on hard-chrome steel treated ground tie bars
  • Stainless steel hopper with magnetic grill mounted on a swiveling system
  • Injection speed, pressure and holding time profile on 7 steps
  • Proportional valve for pressure and flow control with electronic feedback
  • Suction and return oil filter
  • Component easily accessible for maintenance purpose
  • Resiliently mounted hydraulic pump
  • Sealed oil tank with oil temperature
  • 24 Volt DC solenoid valve
  • Clamping and injection strokes are monitor by linear transducers
  • M C B Control each heating zone
  • Star Delta starter for pump motor 200 TO 650T
  • Overload protection for pump motor


  •  Optional FeaturesCore pulling System
  • Hydraulic shutoff nozzle
  • Pneumatic gate
  • Hydraulic ejector with liner transducer
  • PET Pre-form Attachment
  • Double Color Attachment
  • Rigid PVC Attachment